Advertisement
78. Install the front and rear unit brackets to the
receiver unit using two 4 x 8 mm washer-screws
and two 4 mm flange nuts for each bracket.
FRONT UNIT
BRACKET
4 mm FLANGE
NUTS (4)
79. Position the receiver unit between the right trunk
side panel and the rear fender panel, and plug in
the antenna cable connectors, the DIN cable
connector, and the XM radio harness connector
using the panel hole to access the receiver unit.
DIN CABLE
XM RADIO
HARNESS
PANEL HOLE
RIGHT TRUNK
SIDE PANEL
© 2003 American Honda Motor Co., Inc - All Rights Reserved.
4 x 8 mm
WASHER SCREWS (4)
RECEIVER
UNIT
REAR UNIT
BRACKET
2527131M
ANTENNA CABLE
FENDER
PANEL
RECEIVER
UNIT
80. Attach the receiver unit to the body panel using
three 6 x 12 mm washer-bolts. Tighten the bolts
securely.
6 x 12 mm
WASHER-BOLTS (3)
DRILLED HOLES (3)
81. Attach two cushion tapes to the edges of the
panel in the areas shown.
PANEL HOLE
82. Inside the fender area, bundle up the excess
antenna cable and DIN cable, and secure them
with one wire tie with clip to the hole in the rear
2621010M
unit bracket.
83. Wrap the ends of the antenna cable and the DIN
cable with two cushion tapes.
AII 24378 (0303)
CUSHION
TAPES
WIRE TIE
CUSHION TAPES (2)
WITH CLIP
RECEIVER UNIT
2621020M
ANTENNA CABLE
AND DIN CABLE
2621031M
23 of 24
Advertisement
