Advertisement
50. Plug the BUS cable connector into the vehicle
connector. If the vehicle is equipped with a
navigation system, wrap the connectors with one
EPT seal.
VEHICLE
CONNECTOR
(with navigation
system)
BUS CABLE
CONNECTOR
(with
navigation
system)
LEFT PLAYER
BRACKET
(with
player)
6 mm
FLANGE
NUTS (4)
(with pocket)
51. Install the display module assembly onto the
studs of the left and right player subbrackets, and
install the 6 mm flange nuts. Tighten the flange
nuts securely.
52. If the vehicle is not equipped with a player, attach
the two grommet screws to the player panel in the
square holes as shown.
GROMMET SCREWS
© 2003 American Honda Motor Co., Inc - All Rights Reserved.
VEHICLE
CONNECTOR
(without navigation
system)
EPT SEAL
BUS CABLE
CONNECTOR
(without
navigation
system)
LEFT PLAYER
SUBBRACKET
STUD
2N28150M
RIGHT PLAYER
BRACKET
DISPLAY
MODULE
ASSEMBLY
PLAYER
PANEL
2306131T
AII 24378 (0303)
53. Get one EPT seal. Measure the EPT seal, and
use scissors to cut it into three pieces.
EPT SEAL
(Cut off the
marked area.)
EPT SEAL
54. Using isopropyl alcohol on a shop towel, clean the
player panel in the area shown. Attach the two cut
pieces of the EPT seal to the player panel, and
cut off the excess.
55. Attach the player panel by inserting the clips into
the latches, and install two self-tapping screws
from the kit or reinstall the two self-tapping screws
you removed in step 13. Remove the masking
tape.
CLIP
PLAYER
PANEL
SELF-
TAPPING
SCREWS
(Reuse.)
PLAYER
PANEL
8 mm
8 mm
2612010T
LATCH
2306141T
17 of 24
Advertisement
