Table of Contents
Advertisement
PRIOR TO USE
Installing the adapter
The adapter can be installed to a board (up to 8 mm or
5/16 in. in thickness) such as the inner wall of a job site
box using the supplied spanners.
Make four installation holes with a diameter of 7 mm
(9/32 in.) on a board to form the corners of a rectangle
114 mm (4-1/2 in.) high and 57 mm (2-1/4 in.) across.
Secure the adapter using the four spanners (a) and the
spanner bit supplied with the adapter.
Installing the mobile app
Supported mobile devices
Mobile device
OS
Note that support for all NFC-enabled Android devices
is not guaranteed.
Installing the mobile app
The app is only downloadable from the Google Play
Store. A Google account is needed to use the Google
Play Store.
NOTE: The mobile device must be connected to a
cellular network or Wi-Fi network.
NOTE: Be sure to enable Wi-Fi when connecting to a
Wi-Fi network in a Wi-Fi enabled area.
1. Go to the Google account sign-in page and create
a Google account. (If you already have a Google
account, skip this step.)
NOTICE: Read the Terms of Service and Privacy
Policy before creating a Google account. Makita
Corporation is not responsible for damages resulting
from the creation or use of a Google account.
2. Tap "Play Store" on your device to sign in to the
Google Play Store.
NFC-enabled Android devices
Android 4.2 or later
114 mm
(4-1/2 in.)
1.
2.
4 ENGLISH
7 mm
(9/32 in.) dia.
a
Up to 8 mm
(5/16 in.)
57 mm
(2-1/4 in.)
Advertisement
Table of Contents
