Table of Contents
Advertisement
TROUBLESHOOTING
NOTICE: If the problem persists after the remedial
action is taken, consult your nearest Makita Service
Center.
Symptom
•
The PIN codes set for the adapter and
the battery cartridge are not identical.
Set the same PIN code for the battery
The
Warning
cartridge and the adapter.
lamp blinks steadily.
•
The battery cartridge is not compatible
with the adapter.
Use a compatible battery cartridge.
You forgot the PIN
Consult your nearest Makita Service
code and cannot
Center to clear the battery settings.
change settings.
All segments of
the level indicator
•
The battery cartridge will expire in
on the battery
approximately one hour.
cartridge flash.
The
Warning
lamp flashes
Replace the coin cell battery.
intermittently or
rapidly.
Replace the coin cell battery.
The adapter
If you are using the PC app, connect
malfunctions.
the PC to the adapter before operating
the app.
You cannot update
Connect the adapter to the PC with a
the adapter using
USB cable.
the PC app.
Install the adapter driver to the PC.
SPECIFICATIONS
Applicable lithium-ion (Li-ion)
battery cartridges
Power supply
Operating temperature/
humidity
Dimensions (W x L x H)
Weight
(incl. coin cell battery)
•
The specifications here are subject to change
without notice, due to our continuing program of
research and development.
•
Specifications may differ from country to country.
FCC statement
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Cause/Remedy
BL1830B, BL1850B, BL1430B,
and other battery cartridges
with model numbers ending in
"B" or "C"
CR2450 (3 V DC, 10 mA) x 1
0°C - 40°C (32°F - 104°F)
35% - 85% (without
condensation)
Approx. 80 x 165 x 62 mm
(3-1/8 x 6-1/2 x 2-7/16 in.)
Approx. 0.25 kg (8.8 oz.)
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and
receiver.
-
Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
-
Consult the dealer or an experienced radio/TV
technician for help.
NOTE: Changes or modifications not expressly
approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Makita U.S.A. Inc.
14930 Northam Street, La Mirada, CA 90638-5753,
USA +1-(714) 522-8088
CAN ICES-3 (B)/NMB-3(B)
DISCLAIMER
•
The mobile and PC apps are only for use with
Makita products.
•
Makita Corporation is not responsible for damages
incurred by the user (including direct damages,
special damages, consequential damages, punitive
damages, penalties, loss of data, loss of profit
and resulting damages, or fees for procuring a
replacement device) resulting from the use of the
apps.
•
The screenshots in this document may differ from
the content displayed on your mobile device or PC.
•
No part of this document may be copied,
reproduced, modified, or reused in any form.
•
For details on the NFC contact point of your mobile
device, contact the device manufacturer.
•
The N-Mark (
trademark of NFC Forum, Inc. in the United States
and in other countries.
•
This product and document do not bear or use the
™ and ® symbols.
•
The names of products, companies, etc. appearing
in this document are trademarks or registered
trademarks of their respective companies.
23 ENGLISH
) is a trademark or registered
Advertisement
Table of Contents
