Table of Contents
Advertisement
Connecting Cisco Analog Video Gateway Network Modules to the Network
Figure 3
EVM
IPVS-16A
Table 3
EVM-IPVS-16A Network Module LED Descriptions
Figure
Ref.
LED
State
1
LINK
Green
Off
2
ACT
Amber
Off
3
Video
Green
signal
ports
Amber
0-15
Off
4
EN
On
Off
How to Install, Connect, or Replace the EVM-IPVS-16A Network
Module
This section contains the following procedures, each of which may or may not be required, depending
on which tasks your service provider performs for you:
•
•
EVM-IPVS-16A Network Module LEDs
20
3210
Meaning
Gigabit Ethernet link is up.
Gigabit Ethernet link is down.
Gigabit Ethernet link is actively
transmitting or receiving.
Gigabit Ethernet link is not actively
transmitting or receiving.
There is an active video session for this
port, and input video is detected.
There is an active video session for this
port, but no input video is detected.
There is no active video session for this
port.
The router's Cisco IOS software recognizes
the network module.
The router's Cisco IOS software does not
recognize the network module.
Installing the EVM-IPVS-16A Network Module in the Router Chassis, page 6
Connecting the EVM-IPVS-16A Network Module to the Network, page 8
Connecting Cisco Analog Video Gateway Network Modules to the Network
How to Install, Connect, or Replace the EVM-IPVS-16A Network Module
11
1
1
2
Possible Causes and Corrective Actions
Normal indication. No action required.
Check Gigabit Ethernet cable connections.
Normal indication. No action required.
Normal indication. No action required.
Normal indication. No action required.
Check the camera is on, then check the video
port cable connections.
Check the video port cable connections.
See the
Network Module to the Network" section on
page
8.
Normal indication. No action required.
Verify that the network module is properly
installed in the router chassis. See the
Cisco Network Modules in Cisco Access
Routers" chapter.
3
"Connecting the EVM-IPVS-16A
4
"Installing
5
Advertisement
Table of Contents
