Changing The Administrator Username And Password; Troubleshoot Your Connection - Cisco RV340 Quick Start Manual

Save any additional configuration changes and log out of the
S 10
TEP
device manager.

Changing the Administrator Username and Password

To change the Administrator username and password on the device:
From the Getting Started page, select Change Administrator
S 1
TEP
Password or select Setup > Password from the navigation bar.
Change the Username.
S 2
TEP
Enter the Old Password.
S 3
TEP
Enter the New Password.
S 4
TEP
Confirm the New Password.
S 5
TEP
Click Save.
S 6
TEP

Troubleshoot Your Connection

If you cannot access your device by using the Setup Wizard, the device
may not be reachable from your computer. You can test network
connections by using ping on a computer running Windows:
Open a command window by using Start > Run and enter cmd.
S 1
TEP
At the Command window prompt, enter ping and the device IP
S 2
TEP
address. For example, ping 192.168.1.1 (the default static IP
address of the device).
If you can reach the device, you should get a reply similar to the
following:
Pinging 192.168.1.1 with 32 bytes of data:
Reply from 192.168.1.1: bytes=32 time<1ms TTL=128
If you cannot reach the device, you should get a reply similar to the
following:
Pinging 192.168.1.1 with 32 bytes of data:
Request timed out.
8 Cisco RV340 Router Quick Start Guide