Back Panel; Side Panel - Cisco RV340 Quick Start Manual

Power
VPN
USB1 and USB2

Back Panel

POWER—Toggles power to the device on or off.
12VDC (1.5A)—Power port that connects the device to the provided
12VDC, 1.5 amp power adapter.
RESET—Reboot or reboot and restore defaults:
• To reboot the unit and retain the current configuration, press and hold
RESET for at least 3, but no more than 10 seconds, by using a paper clip
or a pen tip.
• To reboot the unit and restore the factory default settings, press and
hold in the RESET button for more than 10 seconds. Changes made to
the original configuration of your device are lost.

Side Panel

USB —Type A USB port that supports flash drives and 3G/4G/LTE USB
dongles. Caution: Use only the power supply provided with the device;
using another power supply may cause the USB dongle to fail.
Kensington Lock Slot - Lock slot on the right side to secure the device
physically, using the Kensington lockdown equipment.
Cisco RV340 Router Quick Start Guide
Off when the device is powered off.
Solid green when the device is powered on and
booted.
Flashing green when the device is booting up.
Off when no VPN tunnel is defined, or all defined
VPN tunnels have been disabled.
Solid green when at least one VPN tunnel is up.
Flashing green when sending or receiving data
over VPN tunnel.
Solid amber when no enabled VPN tunnel is up.
Off when no USB device is connected, or is
inserted but not recognized.
Solid green when the USB dongle is connected
to the ISP successfully. USB storage is
recognized.
Flashing green when sending or receiving data.
Solid amber when the USB dongle is recognized
but fails to connect to ISP (no IP address is
assigned). The USB storage access has errors.
5