Table of Contents
Advertisement
RESET (Integral) adjusts controller output according to variation (SP-PV) magnitude
and lasting time. Amount of adjustment depends on that value, or the gain. Reset
adjustments are measured according to the number of proportional action repetition per
minute, or the number of minutes during which the proportional action repetition was
taking place.
(4) Control Direction selection button : It is changeable only at STOP mode.
Button to select Direct/Reverse operation of PID control operation.
Reverse : Heating
Proportional
Direct : Cooling
Proportional
(5) FUZZY control selection button
Selecting to enable or disable fuzzy control.
(6) FAIL-SAFE:
When analog input sensor type is Voltage/mA(0~10V, 1~5V, 4~20mA..), if input fail
status(Burn out, input high, input low) occurs, the control output become fail-safe value
instead of PID control output.
Set range: -5.0~105.0%
Band
PV
Increase
SP
Band
PV
Increase
SP
- 70 -
OFF Time
Cycle time
ON Time
OFF Time
Cycle time
ON Time
Advertisement
Table of Contents
