Hex Wrench Storage; Removing And Installing Saw Blade - Makita DLS110 Instruction Manual

NOTE: Laser line is factory adjusted so that it is posi-
tioned within 1 mm from the side surface of the blade
(cutting position).
NOTE: When laser line appears dim and hard to see
because of direct sunlight, relocate the work area to a
place where there is less direct sunlight.
Aligning the laser line
Align the cutting line on your workpiece with the laser
line.
A
A) When you want to obtain the correct size on the left
side of workpiece, shift the laser line to the left of the
blade.
B) When you want to obtain the correct size on the right
side of workpiece, shift the laser line to the right of the
blade.
NOTE: Use wood facing against the guide fence
when aligning the cutting line with the laser line at the
side of guide fence in compound cutting (bevel angle
45° and miter angle right 45°).
ASSEMBLY
WARNING:
Always be sure that the tool is
switched off and the battery cartridge is removed
before working on the tool. Failure to switch off and
remove the battery cartridge may result in serious
personal injury.

Hex wrench storage

When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
► 1 . Hex wrench

Removing and installing saw blade

switched off and the battery cartridge is removed
before installing or removing the blade. Accidental
B
start up of the tool may result in serious personal
injury.
vided to install or remove the blade. Failure to use
the wrench may result in overtightening or insufficient
tightening of the hex socket bolt and serious personal
injury.
Always lock the carriage with raised position when
removing and installing the blade. Pull the stopper pin
and rotate it 90° with the carriage raised.
► 1 . Unlocked position 2. Locked position 3. Stopper
18 ENGLISH
WARNING:
Always be sure that the tool is
WARNING:
Use only the Makita wrench pro-
1
3
pin
1
2