Mounting Options - Cisco ASR 5500 Installation Manual

▀ Mounting Options

Mounting Options
There are two options for mounting the chassis in a standard 19-inch equipment rack or telecommunications cabinet:
 Flush mount: In this configuration, the flanges of the mounting brackets are flush with the front of the chassis.
This is the default configuration as shipped. This method is typically used to mount the chassis in a 4-post rack
or equipment cabinet. Refer to
 Mid-mount: In this configuration, the flanges of the mounting brackets are recessed from the front of the
chassis. To do this, the mounting brackets must be removed and reinstalled toward the middle of the chassis.
This method is typically used to mount the chassis in a two-post rack. Refer to
Weight Considerations
The shipping weight of the chassis is approximately 226 lbs (102.5 kg). Please consider the following recommendations
before proceeding:
 If available, use an equipment lift to move the chassis and position it into the rack/cabinet.
 If a lift is not available, reduce the weight of the chassis by following the instructions in
the Chassis Prior to
 Remove all obstructions in the path from the delivery location to the rack/cabinet.
 At least two people should perform the installation. These individuals should be physically able to lift and
control the weight of the chassis.
 When lifting any heavy object, remember to bend at the knees and lift with your legs. Bending at the waist and
lifting with your back could cause personal injury.
Important:
filters are installed. The circuit cards are shipped in separate cartons.
Caution:
fully loaded weight of both chassis and any ancillary equipment.
▄ ASR 5500 Installation Guide
42
Flush
Installation.
The ASR 5500 chassis is shipped with no circuit cards installed. Only the PFUs, fan trays and air
If you are mounting two chassis in a single rack, verify that the rack is rated to handle the combined,
Mount.
Chassis Installation
Mid Mount.
Reducing the Weight of