RMA Shipping Procedures
Rear Cards
The packing instructions in this section apply to the following cards:
Management Input/Output (MIO) or Management Input/Output Universal (UMIO) card
Data Processing Card (DPC) or Data Processing Universal (UDPC)
Important:
cutouts at the rear of the MIO/UMIO and DPC/UDPC foam.
The packaging sequence is as follows:
Step 1
Place the card inside the ESD bag; fold over and seal the bag with an ESD Label as shown in the figure below.
Step 2
Place the card in the carton as shown in the figure below.
Step 3
Place the top piece of foam over the card.
Step 4
Close the carton and seal it with shipping tape. See
Step 5
lace the shipping label on the outside of the carton. See
Rear cards use the larger ESD bags and shipping cartons. There are very slight differences in the
Sealing the Shipment
for additional information.
Labeling the Shipment
Packaging ASR 5500 Cards ▀
for additional information.
ASR 5500 Installation Guide ▄
173