For European countries only Sound pressure level (L ) : 70 dB(A) or less Makita declares that the following Machine(s): Uncertainty (K) : 3 dB(A) Designation of Machine: Cordless Driver Drill The noise level under working may exceed 80 dB (A).
A moment of inattention while oper- available from: ating power tools may result in serious personal Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium 25.2.2015 Use personal protective equipment. Always wear eye protection. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or...
Battery tool use and care WARNING: DO NOT let comfort or familiarity with product (gained from repeated use) replace the manufacturer. A charger that is suitable for strict adherence to safety rules for the subject product. MISUSE or failure to follow the safety when used with another battery pack.
In this situation, release the switch trigger on the tool FUNCTIONAL and stop the application that caused the tool to become overloaded. Then pull the switch trigger again to restart. DESCRIPTION If the tool does not start, the battery is overheated. In this situation, let the battery cool before pulling the switch trigger again.
Switch action Reversing switch action 1. Switch trigger 1. Reversing switch lever CAUTION: Before inserting the battery car- tridge into the tool, always check to see that the CAUTION: Always check the direction of switch trigger actuates properly and returns to rotation before operation.
Installing or removing driver bit/ ASSEMBLY drill bit CAUTION: Always be sure that the tool is For Model DF331D (optional accessory) switched off and the battery cartridge is removed before carrying out any work on the tool. 1. Sleeve 2. Close 3.
as it will go. Turn the sleeve clockwise to tighten the chuck. To remove the driver bit/drill bit, turn the sleeve counterclockwise. Installing or removing driver bit/ socket bit For Model DF031D (optional accessory) 1. Driver bit 2. Bit-piece 3. Sleeve To remove the driver bit, pull the sleeve in the direction of the arrow and pull the driver bit out.
Place the point of the driver bit in the screw head and Installing driver bit holder apply pressure to the tool. Start the tool slowly and then increase the speed gradually. Release the switch trigger Optional accessory as soon as the clutch cuts in. NOTE: When driving wood screw, pre-drill a pilot hole 2/3 the diameter of the screw.
Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result. To maintain product SAFETY and RELIABILITY, be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. OPTIONAL ACCESSORIES 1. Holster holder 2.
Page 12
M a k i t a J a n - Ba p t i s t V i nk s t r aat 2, 3070, B el gi um M ak i t a C or por at i on A nj o, A i c hi , J apan 885440-912 w w w .