Honeywell STT750 Quick Start Installation Manual page 17

Reset Sensor Cal
Sensor CVD
(Applicable for
Pt50, Pt100, Pt200,
Pt500 and Pt1000
RTDs only)
Break Detect
Latching
CJ Type
Fixed CJ Value
(Visible for TC input
only)
LRV
URV
Set LRV
Executing this selection Resets
Confirm the LRV, and URV Corrects
back to Factory values
Enabled, Callendar - Van Dusen RTD
Disabled coefficients for Sensor
Enable, Enable or disable detection of
Disable Input wire break
When enabled, causes all
critical sensor input failures to
latch to the Critical Fault state.
Enable, The fault may only be cleared
Disable by device reset. When
disabled, the critical sensor
input failure will be cleared if
the input recovers.
Determines the source of the
Internal, Cold Junction compensation
Fixed for thermocouple Sensor
types.
When CJ Type is Fixed,
specifies the Cold Junction
temperature value for
thermocouple Sensor types.
####.##
Degrees Celsius. Fixed CJ
temperatures below -50
degrees have no effect on
measured values.
The limits are the Lower
#. ## Range Limit (LRL) and the
#. ## Upper Range Limit (URL) of
the selected Sensor 1 ID
ATTENTION: Executing this
Set
Lower service will set the Lower
Range Range Value (LRV) equal to
Value the input pressure
Quick Start Installation Guide
SmartLine Temperature Transmitter
Press ↵ to
enter
menu
selection
↑ and ↓ to
select
entry.
↵ to enter
Read Only
Parameter
Press ↵ to
enter
menu
selection
↑ and ↓ to
select
entry.
↵ to enter
17