Setting Present Position; Screen 6: Present Position Setup Screen; Screen 10A: View Map Screen - Honeywell KMD-150 Pilot's Manual

GPS Status Screens
of two values, 00 or 30. Only after pressing Key 1 SET is the information
saved and the display reverts to Screen 3, GPS Status Screen.
The local offset is held in RAM and added to UTC time when calculating
ETA's. Default value is +00:00. It is important to set local offset correctly
to ensure ETA's given in NAV Mode are correct.

SETTING PRESENT POSITION

Pressing GPS STATUS
in Main Menu, followed
by SET POSN, accesses
this Screen. On entry to
this Screen a cursor is
positioned over the first
character of the latitude
as shown here. The joy-
stick can then be used to
increment or decrement
values and to move the
cursor right and left.
When new values for lati-

Screen 6: Present Position Setup Screen

tude and longitude have
been selected, pressing Key 1 SET will enter the new latitude and longi-
tude and revert to Screen 3.
Alternatively you can
press Key 4 VIEW MAP
and using the joystick,
simply point at your pre-
sent position.
When Screen 10A is dis-
played you can zoom in
or out using Keys 2 or 3.
By using the joystick you
can 'bump' the borders of
the map window to view
anywhere in the world.
The POS: box at the

Screen 10A: View Map Screen

bottom of the screen dis-
plays the latitude and longitude of the pointer.
Once you have the joystick pointing at your present location, press Key 5
SET POSN to return to Screen 3, where the pointer latitude and longi-
tude will then be fed into the LAST FIX field.
To leave the position unchanged press key 1, PREV PAGE which will
return you to Screen 6.
41
Rev 1 Mar/2000 KMD 150 Pilot's Guide