Pointer Calibration - Grizzly G0636X Owner's Manual

Pointer Calibration

Your new bandsaw is equipped with a fence mea-
surement system that includes a fence pointer,
which must be calibrated when the bandsaw is
first set up.
To calibrate the pointer:
1. If the fence is mounted on the right-hand side
of the blade, remove it and re-install it on the
left-hand side of the blade.
2.
Place the fence flush against the bandsaw
blade (Figure 36).
Figure 36. Example of fence flush with blade.
3. Loosen the pointer adjustment screw (Figures
37–38) and set the pointer in line with "0" and
the measurement scale on the table.
-30-
Figure 37. Model G0636X fence pointer
adjustment screw.
Figure 38. Model G0636XB fence pointer (screw
out of view).
4.
Tighten the pointer adjustment nut.
Model G0636X/G0636XB (Mfd. Since 04/17)
Pointer Screw
Pointer