6.
Loosen the lock lever (Figure 13) so that the
blade tracking knob can rotate.
Blade Tracking Knob
Figure 13. Blade tracking controls.
7.
Spin the upper wheel with one hand and
rotate the blade tracking knob with the other
hand to make the blade ride in the center of
the bandsaw wheel tire.
8.
Tighten the lock lever and close the upper
wheel cover.
For the best performance from your saw, regularly
maintain proper tracking of the blade.
NOTICE
Changes in the blade tension may change
the blade tracking.
Model G0636X/G0636XB (Mfd. Since 04/17)
Lock
Lever
The positive stop allows the table to be quickly
and accurately returned to the horizontal (0˚) posi-
tion after being adjusted to a different angle.
To set the positive stop:
1.
DISCONNECT BANDSAW FROM POWER!
2.
Adjust the blade tension to the appropriate
level for the blade size on the blade tension
scale (see Page 24).
3.
Loosen the jam nut that locks the positive
stop bolt in place.
Stop
Bolt
Figure 14. Positive stop bolt and jam nut (as
Positive Stop
Personal injury or death
can occur if the bandsaw
starts during table adjust-
ments. Disconnect power
from the bandsaw before
performing table adjust-
ments.
Jam Nut
viewed from front).
-19-