Directly Entering The Parameter Number And Value - Siemens SINAMICS G120 Operating Instructions Manual

Appendix
A.2 Handling the BOP 2 operator panel
A.2.3

Directly entering the parameter number and value

Directly select the parameter number
The BOP‑2 offers the possibility of setting the parameter number digit by digit.
Precondition
The parameter number is flashing in the BOP-2 display.
Procedure
To select the parameter number directly, proceed as follows:
1. Press the OK button for longer than five seconds.
2. Change the parameter number digit-by-digit.
If you press the OK button then the BOP‑2 jumps to the next digit.
3. If you have entered all of the digits of the parameter number, press the
OK button.
You have now entered the parameter number directly.
Entering the parameter value directly
The BOP‑2 offers the option of setting the parameter value digit by digit.
Precondition
The parameter value flashes in the BOP-2 display.
Procedure
To select the parameter value directly, proceed as follows:
1. Press the OK button for longer than five seconds.
2. Change the parameter value digit-by-digit.
If you press the OK button then the BOP‑2 jumps to the next digit.
3. If you have entered all of the digits of the parameter value, press the
OK button.
You have now entered the parameter value directly.
528
Converter with the CU230P-2 Control Units
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE