Siemens SINAMICS G120 Operating Instructions Manual page 176

Low voltage converters built-in and wall mounting units with cu230p-2 control units
Hide thumbs Also See for SINAMICS G120:
Table of Contents

Advertisement

Commissioning
5.5 Quick commissioning with a PC
5. When the USB interface is appropriately set, then the "Accessible nodes" screen form
shows the inverters that can be accessed.
Figure 5-17
Figure 5-18
If you have not correctly set the USB interface, then the following "No additional nodes
found" message is displayed. In this case, follow the description below.
6. Further procedure dependent on the commissioning software used:
– STARTER:
– Startdrive:
You have transferred an inverter accessible via the USB interface into your project.
176
Inverters found in STARTER
Inverters found in Startdrive
- Select the inverter ☑.
- Press the "Accept" button.
Transfer the inverter into the project using the menu: "Online - Upload device as new
station (hardware and software)".
Converter with the CU230P-2 Control Units
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinamics g120p

Table of Contents