Makita DCL180 Instruction Manual page 7

Disposing of dust for high
performance ilter
In order to drop dust sticking on the ilter in the capsule,
tap the capsule 4 or 5 times with your hand.
Now point suction inlet downwards, turn capsule in
direction of arrow in diagram, and disconnect capsule
slowly and straight.
► 1. Capsule 2. Suction inlet
NOTE:
• Dust may spill out when capsule is opened, so
be sure to set a garbage bag beneath capsule.
Remove accumulated dust from inside of capsule and
off of high performance ilter.
1
► 1. Capsule 2. High performance ilter
Twist high performance ilter in direction of arrow to
unfasten securing lip from cleaner unit and then pull off
the ilter.
► 1. Securing lip
Clean out the ine dust and lightly tap to dislodge dust
from high performance ilter.
Reassembly
Reassembly for normal ilter
Put on ilter until it is fully in position on the cleaner unit.
1
2
► 1. Filter
NOTE:
•
2
► 1. Filter
Connect preilter. At this time, make sure to twist preil-
ter so that securing lip is irmly locked into cleaner unit.
1
► 1. Preilter
7 ENGLISH
1
Make sure ilter is put on straight without being
peeled back. If ilter is put on incorrectly as
shown in diagram, dust will get into motor hous-
ing, and cause motor failure.
1
1