Makita 4323 Instruction Manual page 12

To install, insert the rip fence into the
rectangular hole on the side of the tool
base with the fence guide facing down.
Slide the rip fence to the desired cutting
width position, then tighten the bolt to
secure it.
Hex wrench
I
2) Circular cuts
When cutting circles or arcs of 170 mm (6-1 1/16") or less in radius, install the rip fence
as follows.
Insert the rip fence into the rectangular hole on the side of the tool base with the fence
guide facing up. Insert the circular guide pin through the either of the two holes on the
fence guide. Screw the threaded knob onto the pin to secure the pin. Now slide the rip
fence to the desired cutting radius, and tighten the bolt to secure it in place. Then move
the tool base all the
way
forward.
Threaded knob
I
Anti-splintering device
(optional accessory)
For splinter-free cuts, the anti-splintering
device can be used. To install the anti-
splintering device, move the tool base all
the way forward and insert it between the
two protrusions of the tool base.
CAUTION:
The anti-splintering device cannot be used
when making bevel cuts.
I I
Anti-splintering device
12