Configuring A Static Rendezvous Point; Overriding Bootstrap Router Updates; Configuring A Designated Router - Dell S3048-ON Configuration Manual

Configuring a Static Rendezvous Point

The rendezvous point (RP) is a PIM-enabled interface on a router that acts as the root a group-specific tree; every group must have an RP.
• Identify an RP by the IP address of a PIM-enabled or Loopback interface.
ip pim rp-address
Example of Viewing an RP on a Loopback Interface
Dell#sh run int loop0
!
interface Loopback 0
ip address 1.1.1.1/32
ip pim sparse-mode
no shutdown
Dell#sh run pim
!
ip pim rp-address 1.1.1.1 group-address 224.0.0.0/4

Overriding Bootstrap Router Updates

PIM-SM routers must know the address of the RP for each group for which they have (*,G) entry.
This address is obtained automatically through the bootstrap router (BSR) mechanism or a static RP configuration.
Use the following command if you have configured a static RP for a group. If you do not use the override option with the following
command, the RPs advertised in the BSR updates take precedence over any statically configured RPs.
• Use the override option to override bootstrap router updates with your static RP configuration.
ip pim rp-address
Examples of Viewing the Rendezvous Point (Multicast Group) Information
To display the assigned RP for a group, use the show ip pim rp command from EXEC privilege mode.
Dell#show ip pim rp
Group RP
225.0.1.40 165.87.50.5
226.1.1.1 165.87.50.5
To display the assigned RP for a group range (group-to-RP mapping), use the show ip pim rp mapping command in EXEC privilege
mode.
Dell#show ip pim rp mapping
PIM Group-to-RP Mappings
Group(s): 224.0.0.0/4, Static
RP: 165.87.50.5, v2

Configuring a Designated Router

Multiple PIM-SM routers might be connected to a single local area network (LAN) segment. One of these routers is elected to act on
behalf of directly connected hosts. This router is the designated router (DR).
The DR is elected using hello messages. Each PIM router learns about its neighbors by periodically sending a hello message out of each
PIM-enabled interface. Hello messages contain the IP address of the interface out of which it is sent and a DR priority value. The router
with the greatest priority value is the DR. If the priority value is the same for two routers, then the router with the greatest IP address is
the DR. By default, the DR priority value is 192, so the IP address determines the DR.
• Assign a DR priority value.
INTERFACE mode
ip pim dr-priority priority-value
PIM Sparse-Mode (PIM-SM) 591