Yamaha MMP1 Operation Manual page 57

15.
Assign the mic preamp output, Cue output,
Studio Speaker output, and the Headphone Out
output.
NOTE
• While holding down the right mouse button (Windows) or
the <control> key (Mac) on the Source fields, drag up or
down on the fields to select several input sources at the
same time.
• The Dante Out name, "to DAW" is set in Settings - Global
- IO Label.
• "Cue" and "Studio Speaker" are found in "Monitor Matrix
Out."
Patch screen - Output Patch
Assign the mic preamp outputs (Analog In 1/2) to
Dante Out 1/2 connected to the recording DAW, and
Cue, STU and Headphone Out to AES/EBU Out 1-6
connected to the headphones and the speakers.
The cue mixes are created now.
5. Configuring System Settings
5-1-4. Talkback settings
16.
Assign Talkback mic output to Talkback Mic In.
Patch screen - Input Patch
Assign Analog In 3/4 connected to the Talkback mic
output to Talkback Mic In 1-1/1-2.
17.
Set the Talkback interrupt destination.
Settings screen - Scene - Talkback Destination
Configure settings to send Talkback signals from mics
assigned to Talkback Mic In 1-1/1-2 to Cue 1 and
Studio Speaker 1.
Set interrupt destination 1 (Destination 1) to Cue 1 and
Studio Speaker 1 from Talkback 1-1 (Bus 1, Mic 1), and
interrupt destination 2 (Destination 2) to Cue 1 and
Studio Speaker 1 from Talkback 1-2 (Bus 1, Mic 2).
MMP1 Operation Manual 57