Yamaha MMP1 Getting Started
Hide thumbs
Also See for MMP1:
- Setup manual (91 pages) ,
- Operation manual (67 pages) ,
- Getting started (28 pages)
Related Manuals for Yamaha MMP1
Summary of Contents for Yamaha MMP1
- Page 1 SIGNAL PROCESSOR Getting Started Einführung Prise en Main Cómo Empezar Introdução Guida Introduttiva Приступая к работе セットアップガイド...
- Page 2 Compliance with FCC by Yamaha Corporation of America or its subsidiaries. * This applies only to products distributed by YAMAHA CORPORATION OF AMERICA. (class B) 이 기기는 가정용 (B 급 ) 전자파적합기기로서 주로...
- Page 3 The above warning is located on the top of the unit. L’avertissement ci-dessus est situé sur le dessus de l’unité. Explanation of Graphical Symbols Explication des symboles The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “danger- ous voltage”...
-
Page 4: Table Of Contents
3-6. Notes regarding the use of network switches.......... 13 3-7. Dante network settings and audio routing ..........13 4. Installing Applications..............14 4-1. MMP1 Editor.................... 14 4-2. MMP1 Controller ..................14 5. Troubleshooting................15 5-5. Restoring factory settings................ 15 6. Specifications..........at the end of the book 6-9. -
Page 5: Precautions
• If any of the following problems occur, immediately turn off compatible. Please check with your Yamaha dealer. the power switch and disconnect the electric plug from the • Check the electric plug periodically and remove any dirt or outlet and also disconnect the connected power supply dust which may have accumulated on it. -
Page 6: Notice
When the backup battery needs to be replaced, the error or damage to the device or other property. These icon will appear on the menu bar of the MMP1 Editor while precautions include, but are not limited to, the the MMP1 is connected to the MMP1 Editor. In this case,... -
Page 7: Information
For proper treatment, recovery and recycling on the menu bar of MMP1 Editor while the MMP1 is connected of old products, please take them to to the MMP1 Editor. If either of these messages appears do... -
Page 8: Welcome
1-5. Nomenclature used in this book Thank you for choosing the Yamaha signal processor MMP1. In order to take full advantage of the MMP1 In order to distinguish between the controls on the MMP1 functionality and enjoy years of trouble-free use, please unit and the controls on the screen, control names are read this manual. -
Page 9: Names And Functions
Green (flashing slowly) The firmware is being updated. the Scene is recalled, and the key is lit continuously. Use the MMP1 Editor to store Scenes. Red (lit continuously) An error has occurred in the memory of the unit. If the issue is still not... -
Page 10: Rear Panel
If there are multiple Dante-compatible devices For connecting the external DC power unit (+12 V, 45 W) from Yamaha that require an ID setting connected to the for backup of AC power supply. The connector type is same network, set a different ID for each device. - Page 11 2. Names and Functions # GPI [INPUT]/[OUTPUT] connectors For connecting GPI-equipped devices. The connector type is D-Sub 25-pin female. Use the MMP1 Editor for detailed GPI settings of the unit. Refer to “Specifications” for current and voltage of each pin, and for pin assignments.
-
Page 12: Location And Connections
3-2-3. IP address down DIP switch 7 and 8 Set the IP address using the MMP1 Editor. Any settings you change while the power is on will be retained and applied the next time you turn the power 3-2-1. UNIT ID Determines the ID for identifying each device on the Dante network. -
Page 13: Precautions For Rack Mounting
0 to 40 degrees Celsius. If you mount this speakers last to avoid speaker damage. Before you set to unit along with other MMP1 unit(s) or other device(s) in an standby the power of the unit, first turn off the power to the EIA standard equipment rack, temperatures inside the power amplifiers and/or powered speakers. -
Page 14: Installing Applications
• To uninstall the MMP1 Editor Windows: In Control Panel, click [Programs and functions] or [Uninstall a program], then select the MMP1 Editor, and click [Uninstall or change]. Mac: double-click the “Uninstall Yamaha MMP1 Editor.app,” and then follow the instructions on screen. -
Page 15: Troubleshooting
Follow the steps below to initialize the internal memory of the unit to the factory programmed settings. In addition to referring to this list of common problems/ solutions, visit the Yamaha Pro Audio website for an FAQ Set the unit to standby. list (Frequently Asked Questions). -
Page 16: Specifications
6. Specifications 6-1. ELECTRICAL CHARACTERISTICS Internal 44.1kHz/48kHz/88.2kHz/96kHz/176.4kHz/192kHz Sampling Frequency External 44.1kHz/48kHz/88.2kHz/96kHz/176.4kHz/192kHz, ±200ppm Frequency Response ±0.5 dB, 20Hz – 20kHz THD+N 0.0031%, A-weighted, +4dB@20Hz – 20kHz, GAIN: 0dB, Fs=192kHz Analog Input/Output Dynamic Range 110dB, A-weighted Crosstalk@1kHz -100dB 6-2. ANALOG INPUT CHARACTERISTICS Input level Input Actual Load... -
Page 17: General Specifications
6-7. CONTROL I/O CHARACTERISTICS Balanced / Terminal Format Level Connector Unbalanced — — D-SUB Connector — 25P (Female) — — — TTL/75Ω terminated WORD CLOCK — — TTL/75Ω • GPI inputs ch1-12: optically isolated. Load current = 3 mA (typical). See figure 1. •... -
Page 18: Pin Assignment
6-10. Pin assignment ANALOG [INPUT] connector Input Ch Signal N.O. 2, 5, 8, 11, 16, 19, 22, Cold ANALOG [OUTPUT] connector Output Ch Signal N.O. 2, 5, 8, 11, 16, 19, 22, Cold [AES/EBU] connectors Data In Ch Data Out Ch Signal N.O. - Page 19 GPI [INPUT] connector GPI Input Channel Signal N.O. IN, IN+ 11, 12 24, 25 GPI [OUTPUT] connector GPI Output Channel Signal N.O.
-
Page 20: Dimensions
6-11. Dimensions Unit: mm The contents of this manual apply to the latest specifications as of the publishing date. To obtain the latest manual, access the Yamaha website then download the manual file. Der Inhalt dieser Bedienungsanleitung gilt für die neuesten technischen Daten zum Zeitpunkt der Veröffentlichung. Um die neueste Version der Anleitung zu erhalten, rufen Sie die Website von Yamaha auf und laden Sie dann die Datei mit der Bedienungsanleitung herunter. -
Page 21: Software Licenses And Copyrights
7. Software Licenses and Copyrights Activities other than copying, distribution and modification are not GNU GENERAL PUBLIC LICENSE covered by this License; they are outside its scope. The act of running the Program is not restricted, and the output from the Program is covered only if its contents constitute a work based on the Program Version 2, June 1991 (independent of having been made by running the Program). - Page 22 c) Accompany it with the information you received as to the offer to countries, so that distribution is permitted only in or among countries distribute corresponding source code. (This alternative is allowed not thus excluded. In such case, this License incorporates the only for noncommercial distribution and only if you received the limitation as if written in the body of this License.
- Page 23 This program is distributed in the hope that it will be useful, but GNU LESSER GENERAL PUBLIC WITHOUT ANY WARRANTY; without even the implied warranty of LICENSE MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for more details. You should have received a copy of the GNU General Public License Version 2.1, February 1999 along with this program;...
- Page 24 We call this license the "Lesser" General Public License because it such modifications or work under the terms of Section 1 above, does Less to protect the user's freedom than the ordinary General provided that you also meet all of these conditions: Public License.
- Page 25 executable is therefore covered by this License. Section 6 states terms 7. You may place library facilities that are a work based on the Library for distribution of such executables. side-by-side in a single library together with other library facilities not covered by this License, and distribute such a combined library, When a "work that uses the Library"...
- Page 26 For three years after the final factory shipment, you may request from PERMITTED BY APPLICABLE LAW. EXCEPT WHEN OTHERWISE Yamaha the source code for any portions of the product which are STATED IN WRITING THE COPYRIGHT HOLDERS AND/OR licensed under the GNU General Public License and the GNU Lesser OTHER PARTIES PROVIDE THE LIBRARY "AS IS"...
- Page 27 à Yamaha les frais d'expédition du derivanti da modifiche (aggiunte/eliminazioni) effettuate al software code. di questo prodotto da terze parti diverse da Yamaha (o da terze parti autorizzate da Yamaha). • Notez que nous déclinons toute responsabilité pour les dommages résultant de modifications (ajouts/suppressions) apportées au...
- Page 29 Manual Development Group Yamaha Pro Audio global website © 2017 Yamaha Corporation http://www.yamahaproaudio.com/ Published 09/2017 MWES*.*- **A0 Yamaha Downloads http://download.yamaha.com/ ZV90460...