Yamaha MMP1 Operation Manual page 29

4-1-8c. Scene Tab/Monitor Matrix
Here you can set the monitor matrix input and output
configuration.
NOTE
Set the connection with the MMP1 to "Offline" before changing
settings.
Monitor Matrix In
Monitor Source Determines the audio format to output
when a Monitor Source is selected on the
Main screen, or on the MMP1 Controller.
Cue Source Set this when controlling the cue mix with
the Nuage system.
Specify monaural or stereo for each
source, from Cue Sources 1-8.
Monitor Matrix Out
Main Monitor For selecting the audio format to be
monitored. Specify the total number of
channels used in the system; for example,
set this to "2" when configuring a stereo
monitor system, "6" for a 5.1 system, and
"12" for a 7.1.4 system.
Cue 1-8 Specify monaural or stereo for each
source, from Cue 1-8. If you do not want to
create cue outputs, set this to "0."
Studio Speaker 1-8 These are channels sent to Studio
Speakers. Specify monaural or stereo for
each channel, from 1-8. If you do not want
to create studio speaker outputs, set this to
"0."
NOTE
A total of 32 channels can be set to Monitor Matrix In and Monitor
Matrix Out when the MMP1's sample rate being used is 96 kHz or
less, and a total of 16 channels can be set when the MMP1's
sample rate is higher than 96 kHz.
4-1-8d. Scene Tab/Speaker Matrix
Here you can set the Speaker Set configuration and
speaker matrix input stage filters.
Speaker Matrix
Source Displays the speaker matrix input sources.
CH Type For audio that is output to the monitor
speakers, the audio sent to the main
speakers should be set to "Monitor," audio
sent to LFE channels to "LFE," and audio
used for other applications to "---."
NOTE
Turn Trim and LPF on or off for LFE channels
from the "Monitor" section on the Sub screen.
Process Type Determines the filter processing type.
NOTE
Process Type can be selected when the CH
Type is set to "Monitor" or "LFE."
IIR: A general-use processing type. While
filter processing rarely results in a delay,
varying delays may result for frequencies
close to the cutoff frequency bands. As such,
you may experience some phase
interference when outputting the same sound
from different speakers.
FIR: A processing type generally referred to
as a "linear phase filter." A set delay amount
will be applied to all frequency bands when
applying filter processing. As such,
outputting the same sound from different
speakers will help prevent phase interference
from occurring. However, such a process
takes time, resulting in a greater delay. A
delay of around 10 msec is expected with the
MMP1.
THRU: Bypass filter processing. Although
filtering is not applied when "THRU" is
selected, the signal is output with the same
delay as that generated by the filter type
specified in Process Type when outputting to
account for the delay from the main channel.
Change to IIR Selects the channels for which the filter is
changed from FIR to IIR when talkback is on
or "Filter Type Change to IIR" of the User
Assignable function is on.
Filter Determines the high pass/low pass filter to
be applied to the input source.
NOTE
Filter can be selected when the CH Type is
"Monitor" or "LFE."
4. Screens
MMP1 Operation Manual 29