Hot-Plug Sff Hard Drive Cage Option - HP ProLiant ML110 G7 Maintenance And Service Manual

Install the access panel.
11.
Install the front bezel
12.
Power on the server.
13.

Hot-plug SFF hard drive cage option

Power down the server (on page 23).
1.
Remove the front bezel
2.
Remove the access panel
3.
Remove any hard drives installed
4.
Disconnect all cables from the drive cage.
5.
Using a T-15 Torx screwdriver, remove the four screws, and then remove the hard drive cage from the
6.
drive cage bay.
("Installing the access
("Installing the front bezel" on page 25).
("Removing the front bezel" on page 25).
("Removing the access
("Removing a hard
panel" on page 24)
panel" on page 24).
drive" on page 30).
Removal and replacement procedures 35