Optical Drive Option - HP ProLiant ML110 G7 Maintenance And Service Manual

Remove the four screws, and then loosen the drive cage.
10.
Route and connect the redundant power supply cables to the system board
11.
73).
Insert the four screws to tighten the drive cage.
12.
Install any device originally in the upper media drive bay.
13.
Install the access panel
14.
Install the front bezel
15.
Power on the server.
16.

Optical drive option

Power down the server (on page 23).
1.
Remove the front bezel
2.
Remove the access panel
3.
("Installing the access
("Installing the front bezel" on page 25).
("Removing the front bezel" on page 25).
("Removing the access
panel" on page 24).
panel" on page 24).
Removal and replacement procedures 41
("Power cabling" on page