Disks; Disk Trays - NETGEAR ReadyNAS 102 Hardware Manual

Disk Trays

All systems except the EDA 500 use standard disk trays. The EDA 500 comes with its own special disk
trays. This section describes both the standard and EDA 500 disk trays.
Note For some disks, first remove the plastic mounting bracket from the disk tray before
you mount the disk to the disk tray. After you mount the disk to the disk tray, use the
screws to secure the disk to the disk tray.
Standard Disk Tray
The following figure shows the features of the standard disk tray. This disk tray is used in all systems except
the EDA 500. For information about the EDA 500 disk tray, see
Figure 62. Standard disk tray
1. Disk tray
2. Disk tray release latch
3. Recessed disk tray handle lock
4. Disk tray handle
5. Disk screw holes
6. Mounting bracket
7. Bracket lock
IMPORTANT:
To maintain adequate airflow, make sure that all disk trays remain in the drive
bays, even if no disk is installed in the tray. Do not use standard disk trays
with the EDA 500. Use only EDA 500 disk trays with the EDA 500.
ReadyNAS OS 6 Desktop Storage Systems

Disks

163
EDA 500 Disk Tray on page 164.