Video Filter Level Setting; Audio Encode Setting; Audio Level Setting; Methods For Setting Chapter Mark Insertion - Pioneer PRV-LX10 Operating Instructions Manual

Pioneer dvd recorder operating instructions prv-lx10
Hide thumbs Also See for PRV-LX10:
Table of Contents

Advertisement

Video Filter Level Setting

Use the Video filter to improve image quality when
the Video encode rate setting is low or when there is
noise in the video source. A higher filter level
reduces noise more efficiently but lowers resolution.
Set the level where you obtain the greatest amount
of noise reduction with the lowest loss of resolution.
SET UP section = [Recording] = [Video/Audio]
= [Video Filter (NR)]

Audio Encode Setting

Select Dolby Digital or LPCM audio encoding. As
shown in the table on pages 78 and 79, the
recording time differs depending on the selected
encode setting even at the same recording rate.
Note:
"LPCM" cannot be selected when "DV" is selected
as the input source.
R ) ]
SET UP section = [Recording] = [Video/Audio]
= [Audio Encode]

Audio Level Setting

The SET UP section = [Recording] = [Video/
Audio] = [Audio Level] command allows you to set
the audio level for recording.
Adjust the audio level when the audio source is too
low or so large the sound is distorted to obtain an
appropriate sound setting.
Select R or L and press the Up/Down key to adjust
the sound in the right or left channel (the numbers
are incremented or decremented by each press of
the Up/Down key). To adjust both the right and left
channels, select "L+R" and press the Up/Down key.
Adjust the audio level so that maximum level does
not light the top indicator on the level meter.
SET UP section = [Recording] = [Video/Audio]
= [Audio Level]
Methods for Setting Chapter Mark
Insertion
This function sets how chapter marks are set during
recording.
In Manual mode, chapter marks can be entered at
desired locations by using the main unit's front panel
ENTER button, the remote control unit's ENTER
button, the Enter key on a connected keyboard, The
PAUSE button also can be used to enter chapter
marks during recording standby.
Chapter marks can be automatically set at intervals
range from 3 to 60 minutes. In this case, the ENTER
and PAUSE buttons cannot be used to enter
chapter marks.
SET UP section = [Recording] = [Others]
= [Auto Chapter]
Recording
37

PRV-LX10

En

Advertisement

Table of Contents
loading

Table of Contents