Honeywell HDZ302D User Manual page 66

66 | equIP® Series 30x Zoom WDR PTZ Camera User Guide
To enable the alarm function:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. In the Alarm Delay field, enter the number of seconds that the system will continue to
11. To send an email notification when an alarm event is detected, select the Send Email
12. To initiate a predefined preset, tour, or pattern when an alarm event is detected, select the
13. To take a snapshot when an alarm event is detected, select the Snapshot check box.
www.honeywell.com/security
Select the Enable check box.
From the Alarm Input list, select the alarm input that you want to configure (Alarm1 or
Alarm2).
Next to Alarm Period, click Setup. The Alarm Period window opens.
Set the days and times when you want the alarm function to be active, and then click
Save.
In the Anti-Dither field, enter the anti-dither time in seconds. Enter a value between 0
and 100 seconds. The system will only allow one alarm event within this period.
Set Sensor Type to NO (normally open) or NC (normally closed), depending on the alarm
input type.
To start recording video when an alarm event is detected, select the Record check box.
In the Record Delay field, enter the number of seconds that the system will continue to
record video after an alarm event has ended. Enter a value between 10 and 300.
To generate an alarm output when an alarm event is detected, select the Alarm Output
check box and select the alarm output(s) to be activated.
generate an alarm output after an alarm event has ended. Enter a value between 10 and
300.
check box. Email settings must be configured in Setup > Network Setup > SMTP (Email).
See Configuring Email Settings
PTZ check box and select the desired action from the Activation list.
on page 59.