Configuration Examples For Load Splitting Ip Multicast Traffic Over Ecmp; Example Enabling Ecmp Multicast Load Splitting Based On Source Address - Cisco Catalyst 3850 series Configuration Manual

IP Multicast Optimization: IP Multicast Load Splitting across Equal-Cost Paths
Command or Action
Example:
Router(config)# end
Step 6 show ip rpf source-address
[group-address]
Example:
Router# show ip rpf 10.1.1.2
Step 7 show ip route ip-address
Example:
Router# show ip route 10.1.1.2
Related Topics
ECMP Multicast Load Splitting Based on Source Group and Next-Hop Address, on page 355
Example Enabling ECMP Multicast Load Splitting Based on Source Group and Next-Hop Address, on
page 368
Configuration Examples for Load Splitting IP Multicast Traffic
over ECMP

Example Enabling ECMP Multicast Load Splitting Based on Source Address

The following example shows how to enable ECMP multicast load splitting on a router based on source
address using the S-hash algorithm:
ip multicast multipath
Related Topics
Enabling ECMP Multicast Load Splitting Based on Source Address, on page 361
ECMP Multicast Load Splitting Based on Source Address Using the S-Hash Algorithm, on page 353
OL-32598-01

Configuration Examples for Load Splitting IP Multicast Traffic over ECMP

Purpose
(Optional) Displays the information that IP multicast routing uses to perform
the RPF check.
• Use this command to verify RPF selection so as to ensure that IP
multicast traffic is being properly load split.
(Optional) Displays the current state of the IP routing table.
• Use this command to verify that there multiple paths available to a
source or RP for ECMP multicast load splitting.
• For the ip-address argument, enter the IP address of a source to validate
that there are multiple paths available to the source (for shortest path
trees) or the IP address of an RP to validate that there are multiple
paths available to the RP (for shared trees).
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
367