Samsung DCS Programming Manual page 260

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
MMC: 714
FOR: DCS CI CII
Purpose: Assigns an incoming DDI call through ISDN to a specific station, if you have
specified DDI service with your Network Carrier. DDI numbers can be matched to spe-
cific stations depending on day or night mode, or ring plan. You have the option, when
the destination station is busy, of deciding if the call is to be camped on to the destination
station or of clearing the call. A call waiting option allows a second DDI number to be re-
ceived.
iDCS500 '
source for callers to specific DDI numbers.
There is an extra option to adjust the number of digits to be compared by skipping the
programmed counts from the first digit point provided by the Network.
If there is no matching number in the DDI NUMBER TABLE, the system routes the call to
the operator group (by default) or to the destination assigned in
Maximum number of entries is:
DCS & CII 816
200 50
Each entry consists of the following fields.
DIGITS (DGT)
MOH SOURCE
(iDCS500 'L' &
OS500 systems
only)
DESTINATION
CALL WAIT (CW)
MAX COUNT (MC)
DELETE or DC
NAME
DDI NUMBER AND NAME
TRANSLATION
816 408i
iDCS100
L' and OS500 system administrators can also define a Music-On-Hold
408 & 408i iDCS100
20 500
Digits to be received (max. 12 digits). Wild card ( ) is a valid entry.
Music-On-Hold source for DDI calls put on hold. There is a total of six
possible music selections. In addition to "TONE", you may select an in-
ternal or external music source. Other sources can be:
•
An Auto Attendant (AA) port to provide continuous play of a specific
recording. The AA port selected must be the last AA port on the AA
card (3958). If selected, the Music-on-Hold will be the message de-
fined in MMC
•
A Voice Mail card to select a recording as a music source. The re-
cording must already be defined in
as the voice mail port associated with the recording.
Destination can be a station, a station group, a trunk or trunk group. A
destination can be selected for both day and night mode, or for each ring
plan for iDCS systems. (The character "B" is acceptable to bypass.)
Allow a second DDI call to be received. Toggles YES or NO.
Limits number of incoming calls on a DDI (OS500 only).
Decides the number of digits not to be translated from the first digit re-
ceived. This is useful when the received digits are prefixed with the same
digit(s).
Gives a name to an individual entry (11 characters maximum). Names
are written using the keypad in the same way as speed dial names (see
MMC 706).
MMC 714 (Page 1 of 4)
iDCS500
iDCS500 'M' iDCS500 'L'
400
736.
MMC PROGRAMS
FEBRUARY 2004
OS500
MMC 406.
OS500
999 999
MMC 756 and will show up here