Cisco 8861 Deployment Manual page 133

Video Capabilities
Web Access
Days Display Not Active
Display On Time
Display On Duration
Display Idle Timeout
Display On When Incoming Call
Enable Power Save Plus
Cisco IP Phone 8861 and 8865 Wireless LAN Deployment Guide
When enabled, indicates that the phone will participate in video calls when
connected to an appropriately equipped PC.
This parameter indicates whether the phone will accept connections from a web
browser or other HTTP client. Disabling the web server functionality of the
phone will block access to the phones internal web pages. These pages provide
statistics and configuration information. Features, such as QRT ( Quality Report
Tool ), will not function properly without access to the phones web pages. This
setting will also affect any serviceability application such as CiscoWorks 2000
that relies on web access.
This field allows the user to specify the days that the display is to remain off by
default. Typically this would be Saturday and Sunday for US corporate
customers. Saturday and Sunday should be the default. The list contains all of the
days of the week. To turn off display on Saturday and Sunday the User would
hold down Control and select Saturday and Sunday.
This field indicates the time of day the display is to automatically turn itself on
for days listed in the off schedule. The value should be in a 24 hour format.
Where 0:00 is the beginning of the day and 23:59 is the end of the day. Leaving
this field blank will activate the display at the default time of the day (e.g. -
"7:30"). To set the display to turn on at 7:00AM the user would enter "07:00"
without the quotes. To have the display to turn on at 2:00PM enter "14:00"
without the quotes.
This field indicates the amount of time the display is to be active for when it is
turned on by the programmed schedule. No value indicates the end of the day.
Maximum value is 24 hours. This value is in free form hours and minutes. "1:30"
would activate the display for one hour and 30 minutes.
This field indicates how long to wait before the display is turned off when it was
turned on by user activity. This inactivity timer will continually reset itself during
user activity. Leaving this field blank will make the phone use a pre-determined
default value of one hour. Maximum value is 24 hours. This value can be in free
form hours and minutes. "1:30" would turn off the display after one hour and 30
minutes of inactivity
This field indicates whether LCD display is on when there is an incoming call. If
the field is set to Enabled (default), the LCD display will turn on (if off) when a
call is received. If Disabled, the LCD display will not turn on when a call is
received.
To enable the Power Save Plus feature, select the day(s) that you want the phone
to power off on schedule. You can select multiple days by pressing and holding
the Control key while clicking on the days that you want Power Save Plus to
operate. The default is disabled (no days selected). In Power Save Plus mode,
enough power is maintained to illuminate one key. All other functions of the
phone are turned off in Power Save Plus mode. Power Save Plus mode turns off
the phone for the time period specified in the Phone On Time and Phone Off
Time fields. This time period is usually outside of your organization's regular
operating hours. The illuminated key allows a user to press it to restore full power
to the phone. After pressing the illuminated key, the phone power-cycles and
reregisters with Unified CM before it becomes fully operational. Power Save Plus
is disabled by default. When you select day(s) in this field, the following notice
displays to indicate e911 concerns. By enabling Power Save Plus, you are
agreeing to the terms specified in this Notice. Notice: WHILE POWER SAVE
PLUS MODE (THE "MODE") IS IN EFFECT, ENDPOINTS CONFIGURED
FOR THE MODE ARE DISABLED FOR EMERGENCY CALLING AND
133