Layer 2 Commands - Dell N1100-ON Reference Manual

• VC — VLAN Configuration (reached via vlan command)
• VRC—VRF Configuration
• VR—Virtual Router Configuration
• v6ACL — IPv6 Access List Configuration
• v6CMC — IPv6 Class-Map Configuration
• v6DP — IPv6 DHCP Pool Configuration

Layer 2 Commands

ACL
Command
ip access-list
deny | permit (IP ACL)
deny | permit (Mac-Access-
List-Configuration)
ip access-group
mac access-group
mac access-list extended
mac access-list extended
rename
Description
Creates an Access Control List (ACL) that is
identified by the parameter accesslistnumber.
The deny command denies traffic if the
conditions defined in the deny statement are
matched. The permit command allows traffic if
the conditions defined in the permit statement
are matched.
The deny command denies traffic if the
conditions defined in the deny statement are
matched. The permit command allows traffic if
the conditions defined in the permit statement
are matched.
Attaches a specified access-control list to an
interface.
Attaches a specific MAC Access Control List
(ACL) to an interface in the in-bound
direction.
Creates the MAC Access Control List (ACL)
identified by the name parameter.
Renames the existing MAC Access Control List
(ACL) name.
Dell EMC Networking CLI
a
Mode
GC
ML
ML
GC or
IC
GC or
IC
GC
GC
103