Honeywell NEXPTZ-PD Installation And Operation Manual page 16

Program and Operation
5. After aiming the camera (view direction and lens control) at specific position, push the focus
button(Near, Far). The selected location No. field will be filled with "A A F". Push the joystick
to the right to select each Focus/ Iris /BLC mode using zoom handle.
6. Move the cursor to the title field to edit/enter the title. Rotate the handle CW and CCW to
scroll through the alphanumeric characters. Push the handle to right or left to select next or
previous digit.
7. To finish entering the title, Select Save and Exit by pushing the Joystick to the right.
Locate the cursor on "PREV NEXT" item to select the previous/next page of presets, scroll
8.
the page by pushing the Joystick to the Left on "PREV NEXT".
9. Repeat steps 2 through 8 for each additional preset position.
10. Select Save and Exit by pushing the Joystick to the right. Press ESC to exit the Preset menu
without saving
NOTE: Press the "Home" or "OFF" button at programmed position to delete a programmed
preset view.
<Shortcut of Preset Program>
Select direction of the camera, zoom and focus to be programmed, then press No. (1~128),
and then press Shift, Preset subsequently. The current view will be stored to the selected
preset number if position is empty. If selected preset number is not empty, "PRESET
EXISTING" message will be displayed on the monitor and you will be prompted to overwrite.
Example: 1, 0 + shift + Preset will memorize current view as preset No. 10. In this case, focus and
Iris mode will be memorized as auto and dwell time will be set to 3 sec.
- 16 -