Cisco 8800 Manual page 4

Connect a Key Expansion Module to a Cisco IP Phone
Procedure
Step 1 Unplug the Ethernet cable from the phone.
Step 2 If installed, remove the footstand from the phone.
Step 3 Locate the accessory connector covers on the side of the phone.
This diagram shows the location.
Step 4 Remove the two accessory connector covers, as shown in the diagram.
Caution
Cisco IP Phone 8800 Series Administration Guide for Cisco Unified Communications Manager
4
The slots are designed for the spine connector only. Insertion of other objects will cause permanent
damage to the phone.
Cisco IP Phone Key Expansion Module