Hitachi Compute Blade 500 Series Web Console Users Manual page 100

Power ON
LP Settings
Note: When Refresh is clicked after the command turning on a server
blade is executed, a message showing that an LPAR manager is booting is
displayed until the completion of booting the server blade. (When
Refresh is not clicked, the contents displayed on the screen are not
changed.) However, when Refresh is clicked immediately after the
command turning on a server blade is executed, any of the following
messages is shown.
•
•
In this case, click Refresh after a while.
• LP mode: Enabled; server blade: powered on
Table 2-96 Items when the server blade is powered on in LP mode:
#
2-90
Table 2-95 Items when the server blade is powered off in LP mode
Item
Powers on the LPAR manager.
Shows the LPAR manager Settings dialog box.
Message showing that retrieving the data for the state of LPAR
manager failed
Message showing that LPAR manager is being shut down
Item
Shows LPAR number.
Operating the Web Console
Hitachi Compute Blade 500 Series Web Console User's Guide
Description
Enabled
Description