Table of Contents
Advertisement
Switch Installation
Connecting to Power
Figure 11
Inserting Wires in the Power Connector
1
Power source positive connection
7.
Use a ratcheting torque flathead screwdriver to torque the power connector captive screws (above the installed wire
leads) to 5in-lb (0.565 Nm). See
Caution:
Do not over-torque the power connector's captive screws. The torque should not exceed 5in-lb (0.565
Nm).
1
2
2
Figure 12 on page
26.
25
Power source return connection
Hide quick links:
Advertisement
Table of Contents
