Streamer LTO-3 half height 400GB/800GB SCSI Ultra320
Mounting the streamer
The streamer requires a 5 ¼" mounting location of half height.
It can be mounted horizontally or vertically.
►
Switch off the system and open the casing.
►
If required, attach the mounting rails.
►
Set the correct SCSI ID.
SCSI ID 7 is used by the SCSI-Controller, don't set this ID.
!
The preset SCSI address is 6.
►
Mount the streamer into the system.
►
Attach the SCSI cable to the SCSI adapter (add-on card or onboard) or to the SCSI backplane
(periphery box, e.g. SX10).
Ensure that the SCSI bus operates in LVD mode.
!
Some SCSI controller allow the connection of devices to SE and LVD/SE. Connect in such a
case the SCSI cable always to the LVD/SE connector, never to the SE connector (see the
Quick Start Guide)
SCSI Bus mode SE (Single Ended) is not allowed and leads to losses speed and to
exceeding abrasion of the streamer and magnetic tape cartridges.
Mounting position
T he streamer can be installed either in a horizontal or in a vertical different position.
Do not cover the ventilation slots at the front of the streamer.
!
The streamer must be cooled sufficiently.
Do not expose the streamer to extreme environmental conditions (see chapter
"Technical Data"). Protect the streamer from dust, humidity and heat.
The streamer must not installed headfirst.
10 - English
A26361-H986-Z100-1-7619