Chapter 11 Symbologies; Overview - Motorola Symbol MS4404 Integration Manual

Chapter 11 Symbologies

Overview

This chapter describes symbology features and provides programming bar codes for selecting these features.
Before programming, follow the instructions in
The imager ships with the settings shown in the
Standard Defaults
programming is not necessary.
There are two ways to change a parameter value:
•
Capture the appropriate bar codes in this guide. These new values replace the standard default values in
memory.
•
For SSI and USB SNAPI hosts, send a parameter send command from the host system. Hexadecimal
parameter numbers appear in this chapter below the parameter title, and options appear in parenthesis
beneath the accompanying bar codes. Refer to the Simple Serial Interface (SSI) Programmer Guide for
instructions for changing parameter values using this method.
NOTE Most computer monitors allow capturing the bar codes directly on the screen. When capturing from the
screen, be sure to set the document magnification to a level where you can see the bar code clearly, and
bars and/or spaces do not merge.
To return all features to default values, capture
code menus, asterisks (
for all host device and miscellaneous defaults). If the default values suit requirements,
*
) indicate default values.
*
Indicates Default
Chapter 1, Getting Started.
Symbology Default Table on page 11-2
*Restore Defaults on page
*
Enable UPC-A
Feature/Option
(00h)
(also see Appendix A,
6-4. Throughout the programming bar