Nixdorf Beep/LED Options
If you selected Nixdorf Mode B, this indicates when the imager beeps and turns on its LED after a decode.
*
Normal Operation
(Beep/LED immediately after decode)
Beep/LED After CTS Pulse
Ignore Unknown Characters
Unknown characters are characters the host does not recognize. Select Send Bar Codes with Unknown
Characters to send all bar code data except for unknown characters. The imager emits no error beeps.
Select Do Not Send Bar Codes With Unknown Characters to send bar code data up to the first unknown
character. The imager emits an error beep.
*
Send Bar Code
(with unknown characters)
RS-232 (TTL Serial) Interface 9 - 17
Beep/LED After Transmission
Do Not Send Bar Codes
(with unknown characters)