Preparing To Use The Cisco Bwx360 Wimax Outdoor Modem - Cisco BWX360 Installation Manual

Cisco BWX360 WiMAX Outdoor Modem / engbt / 253306943 / Installation.fm / 07.04.2010
Preparing the power supply
1. Check that all of the assembly steps and connections up to this point have been
made correctly and in full.
2. Connect the supplied power supply unit to the POWER connector of the indoor unit.
Only use the Cisco BWX360 WiMAX Outdoor Modem with the supplied
power supply unit.
Part number: C39280-Z4-C584
Input: 100-240 V, 0.95 A AC
Output: 56 V, 0.55 A DC
3. Begin putting the system into service.
As soon as you have connected the indoor unit to the mains power supply, the sys-
tem is started up.

Preparing to use the Cisco BWX360 WiMAX Outdoor Modem

1. Start up the connected PC or laptop and make any necessary settings. You will find
the preconditions for the PC in the user guide for the Cisco BWX360 WiMAX Out-
door Modem.
2. If you are sure you have connected everything up correctly, connect the indoor unit
to a power socket that is ready for use via the power supply unit.
The system starts up and performs a self-test.
After the self-test, the Cisco BWX360 WiMAX Outdoor Modem continually attempts
to register with a base station. Registration with the base station may be successful
immediately. If not, registration will take place when the Cisco BWX360 WiMAX
Outdoor Modem is being configured (see "Connecting to the WiMAX network and
the Internet" on page 19)
Installing the Cisco BWX360 WiMAX Outdoor Modem
The connection technology between the outdoor modem and the
indoor unit complies with the "PoE" standard. This means the DC
power is supplied via the Ethernet cable
(Pins 4/5 = Power +, Pins 7/8 = Power - )
The DC voltage supplied to the indoor unit is 56 V with a maximum
deviation of 4%.
As part of the standard, a self-test is performed to check the voltage
between the connected devices is correct. The indoor unit only
releases its supply voltage once the outdoor modem and the indoor
unit have accepted the correct voltage.
If the activation is not successful, check whether the connections
have been correctly assembled.
17