Honeywell HRHT4041 Remote User Manual page 67

Table 3-14
Configuration
Region
Record Channel
Delay
WEB - Motion Detection Configurations
Description
1. Select a motion detection type.
2. Click Set. The Motion Detection Set configuration
interface appears.
3. Select the event detection area by left-clicking and
dragging the mouse.
There are 396 (PAL) or 330 (NTSC) small zones.
Green: Indicates the current cursor position.
Grey: Indicates the event detection zone.
Black: Indicates a disarmed zone.
Note Use the FN button on the DVR's front panel to switch
the cursor between selecting and deselecting.
Note When the alarm is armed, you can use the directional
buttons on the DVR to move the green motion
detection rectangle.
4. (Optional) Enter a name in the Zone Name field.
5. Select a Sensitivity, from 1 to 100. The higher the number,
the higher the sensitivity.
6. Select a Threshold, from 1 to 100. The higher the number,
the higher the threshold.
7. Click Save to save the configurations. Click Esc to exit the
setup without saving the changes.
The system automatically starts recording selected channels
when a motion detection alarm occurs.
Note You need to set the motion detection recording period.

Go to Storage Schedule to configure the current channel
for scheduled recording. Refer to the User Guide for more
information about Configuring Recording Schedule Storage
Settings.
The system can delay recording for a specified amount of time
after an alarm has ended. Select from 10s to 300s.
Configuration | 67
800-22740 - A - 02-2017