Boot Run Procedure - Mitsubishi Q00JCPU User Manual

12
PROCEDURE FOR WRITING PROGRAM TO CPU
MODULE

12.1.4 Boot run procedure

This section explains a boot run procedure.
In the following procedure,
indicates that on the Basic model QCPU side.
indicates the operation on the GX Developer side, and
Section 12.1.3
Start (Continued from Section 11.1.3)
When the RUN/STOP/RESET switch is
in the RUN position, set the switch to
the STOP position.
In the boot file setting of the PLC
parameter dialog box, specify "Execute
boot from standard ROM".
Choose [Online] [Write to PLC] on GX
Deveoper, and write the parameters and
program to the program memory.
Choose [Online] [Write to PLC] (Flash
ROM) [Write the program memory to
ROM...] on GX Developer, and write the
program memory data to the standard
ROM.
Power the PLC OFF and then ON, or
reset the CPU module.
NO
Has the special relay
(SM660) turned ON?
YES
End
Figure 12.3 Boot run flowchart
Section 5.1.5
GX Developer Operating Manual
12.1 Basic Model QCPU
12.1.4 Boot run procedure
9
10
11
12
12
- 6