Gx Developer/Got Connection - Mitsubishi Q00JCPU User Manual

7
COMMUNICATION
PORTS OF CPU MODULE

7.2 GX Developer/GOT Connection

The following describes the setting method for connecting the Built-in Ethernet port QCPU
with GX Developer and/or GOT.
POINT
(1) Setting on the Built-in Ethernet port QCPU side
Setting on the Built-in Ethernet port QCPU side is described below.
(a) Set the items on the Built-in Ethernet port tab of PLC parameter in GX
USING
Hub
GX Developer GX Developer
Figure 7.2 Connection example using hub
1. The Built-in Ethernet port QCPU can be connected directly with GX
Developer using one Ethernet cable. (Direct connection (simple connection))
The direct connection (simple connection) enables the QnUDE(H)CPU and
GX Developer to communicate without setting IP addresses. For details, refer
to Section 7.3.
2. For setting on the GOT side, refer to following manual.
GOT1000 Series Connection Manual
Developer as shown in Figure 7.3.
1)
Figure 7.3 Built-in Ethernet port tab
BUILT-IN ETHERNET
Ethernet
7.2 GX Developer/GOT Connection
GOT
2)
7
1
2
3
4
5
6
7
8
- 3