2
Check if the PLC CPU recognizes the GOT. (QCPU (Q mode) only)
Using the [System monitor] of GX Developer, check if the PLC CPU recognizes the GOT or not.
For details on GX Developer operations, refer to the following manual.
GX Developer Version
(1) Check the Module Name, I/O Address and Implementation Position. (The display example is based
on GX Developer Version 8.)
Startup procedure
GX Developer
Not displayed
All settings related to communications are complete now.
Create screens on GT Designer2 and download the project data again.
(1) When you have made sure that the Stage No. and Slot No. currently set to the
Check
Section 2.4
Communication Check
Sheet
(2) If no problems are identified by
Operating Manual
[Diagnostics]
[System monitor]
GOT are correct, mark the check sheet.
Communication setting (Stage No., Slot No.)
Communication check (System alarm of GOT, [System monitor] on GX
Developer)
No error displayed
at all times
and
, then mark the check sheet.
2.2 Preparatory Procedures for Monitoring
2.2.7 Checking for normal monitoring
1
2
3
4
5
6
7
8
2 - 43