Reconfiguration Steps For Boot Block Version 1.02 Or Later - Cisco Aironet 340 Series Hardware Installation Manual

Chapter 4 Troubleshooting
Step 10
Step 11
Step 12
Step 13

Reconfiguration Steps for Boot Block Version 1.02 or Later

Step 1
Step 2
OL-0738-01
If the list of configuration files contains a file called VAR
Note
Installation Key, you need to copy that file to DRAM along
with the installation key. Copy the VAR installation key to
DRAM by pressing c to select Copy file, then 1 to select
DRAM, then the selection letter for the VAR installation
key.
Reformat the Access Point's configuration memory bank by pressing ! to select
FORMAT memory bank, then 2 to select Config, then upper-case Y to confirm
the FORMAT command.
Copy the installation key back to the configuration memory bank by pressing c
to select Copy file, then 2 to select Config, then the selection letter for the AP
Installation Key.
Run the Access Point firmware by pressing r to select Run, then the selection
letter for the firmware file which is displayed. The message "Inflating [firmware
file name]" appears while the Access Point starts the firmware.
When the Express Setup screen appears, begin reconfiguring the Access Point
using the terminal emulator or an Internet browser.
Follow these steps to reconfigure your Access Point if the boot block version on
your Access Point is version 1.02 or later. To find which boot block version is on
your Access Point, follow the steps in the "Determining the Boot-Block Version"
section on page 4-5.
Use a straight-through cable with 9-pin male to 9-pin female connectors to
connect the COM 1 or COM 2 port on your computer to the RS-232 port on the
Access Point.
Open a terminal-emulation program on your computer.
Cisco Aironet Access Point Hardware Installation Guide
Resetting to the Default Configuration
4-7