Connecting the Ethernet and Power Cables
Step 5
Connecting Cables on 350 Series Access Points
Step 1
Step 2
Cisco Aironet Access Point Hardware Installation Guide
2-10
At start-up, all three LEDs on the top of the Access Point slowly blink amber, red,
and green in sequence; the sequence takes a few minutes to complete. During
normal operation, the LEDs blink green. Refer to Chapter 4, "Troubleshooting,"
for LED descriptions.
Follow the steps in Chapter 3, "Basic Configuration" to assign basic settings to
the Access Point.
Follow these steps to connect the Ethernet cable and power supply on 350 series
Access Points:
Plug the RJ-45 Ethernet connector into the Ethernet port on the back of the Access
Point.
Choose a power option for the Access Point. The 350 series Access Point receives
power through the Ethernet cable. Figure 2-4 shows the three power options for
the Access Point.
Chapter 2
Installation
OL-0738-01