Cisco TelePresence SX80 Administrator's Manual page 54

Cisco TelePresence SX80

Introduction
Connect the Touch 10 controller
Connect Touch 10 to the codec via the
network (LAN)
Connect Touch 10 and the codec to network wall sockets
or to a network switch as illustrated.
Touch 10 set-up
Once Touch 10 is connected to power, the set-up
procedure begins. Follow the instructions on screen.
When the Select codec to pair with dialog appears, note
the following:
• A list of codecs signalling that they are available for
paring will show up in the dialog. Tap the name of the
codec you want to pair to followed by
Note that the following must be fulfilled for a codec to
show up in the list:
• The codec and Touch 10 must be on the same
subnet.
• The codec must have been restarted within the last
10 minutes. If the codec does not appear in the list,
try restarting it.
• If the codec does not appear in the list of available
codecs, you can pair the devices manually. Click
codec manually..., enter the IP address or host name of
the codec, and tap Start Pairing.
• You have to enter the codec's administrator username
and password for the paring process to commence.
If Touch 10 needs software upgrade, new software will
be downloaded from the codec and installed on the unit
automatically as part of the set-up procedure. Touch 10
restarts after the upgrade.
D15328.01 SX80 Administrator Guide CE8.0, NOVEMBER 2015.
Configuration Peripherals Peripherals
(page 2 of 3)
Start Pairing.
Power
Select
• 100-240 VAC
• 50/60 Hz
Maintenance
SWITCH
PoE
injector
AP
Contact information
The codec's name or
address is displayed in
the top banner when
Touch 10 is successfully
paired to the codec.
The Ethernet connector
is behind the lid at the
rear of Touch 10.
54
Administrator Guide
System settings
Standard Ethernet cable
Standard Ethernet cable
PoE rated Ethernet cable
If the network infrastructure provides
1
Power over Ethernet (PoE), you do not
need a PoE injector; Touch 10 should
be connected directly to the wall socket
(Ethernet switch) with a PoE rated
Ethernet cable.
For safety, the PoE source must be in
the same building as Touch 10. The PoE
rated Ethernet cable can be up to 100 m
(330 ft).
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
Appendices
Network (LAN)
Network (LAN)
1