•
Enable sFlow globally.
CONFIGURATION mode
[no] sflow enable
Enabling and Disabling sFlow on an
Interface
By default, sFlow is disabled on all interfaces.
This CLI is supported on physical ports and link aggregation group (LAG) ports.
To enable sFlow on a specific interface, use the following command.
•
Enable sFlow on an interface.
INTERFACE mode
[no] sflow enable
To disable sFlow on an interface, use the no version of this command.
sFlow Show Commands
You can display sFlow statistics at the switch, interface, and line card level.
•
Displaying Show sFlow Globally
•
Displaying Show sFlow on an Interface
•
Displaying Show sFlow on a Line Card
Displaying Show sFlow Global
To view sFlow statistics, use the following command.
•
Display sFlow configuration information and statistics.
EXEC mode
show sflow
Example of Viewing sFlow Configuration (Global)
The first bold line indicates sFlow is globally enabled. The second bold lines indicate sFlow is enabled on
linecards Te 1/16 and Te 1/17.
Dell#show sflow
sFlow services are enabled
Global default sampling rate: 32768
Global default counter polling interval: 20
1 collectors configured
Collector IP addr: 133.33.33.53, Agent IP addr: 133.33.33.116, UDP port: 6343
sFlow
1035