Leds; Assigning The Ip Address - Honeywell LANSRLU1 Quick Start User Manual

LANSRLU1

LEDs

The UDS100 device uses LEDs to
indicate the following conditions:
10 Mbps Link/Activity (green)
•
100 Mbps Link/Activity (green)
•
Collisions
•
Diagnostics (red)
•
Status (yellow)
•
10 Mbps Link/Activity steady (green).
10 Mbps Link/Activity blinking (green).
100 Mbps Link/Activity steady (green).
100 Mbps Link/Activity blinking (green).
Collisions blinking red.
Diagnostics steady red and status
blinking green.
Diagnostics blinking red and status
blinking green.
Status steady green.
Status blinking green.

Assigning the IP Address

Method
DeviceInstaller
ARP and Telnet
Serial Port Login
Note: The UDS device is shipped with a default IP address of 0.0.0.0.
4
LEDs
User manually assigns the IP address using a GUI.
The UDS unit must be attached to the network.
User manually assigns the IP address and other net-
work settings at a command prompt using UNIX ro a
Windows based system. The user must be logged
onto the configuration port (9999).
Configure the unit through a serial connection.
Honeywell Access Systems
Definition
Valid 10 Mbps network connection.
Network packets transmitting and receiving.
Valiid 100 Mbps network connection.
Network packets transmitting and receiving.
Network collisions.
1 blink = EPROM checksum error.
2 blinks = RAM error.
4 blinks = EEPROM checksum error.
5 blinks = Duplicate IP address on networ.k
4 blinks = Faulty network connection.
5 blinks = No DHCP response.
Serial port not connected to network.
Serial port connected to network.
Description
7-101002-00